12/12/2023 0 Comments Inboard propeller shaft logThe packing-type gland may be repacked while the shaft is in the boat. We recommend using the same type for the rudder as for the shaft log (#9). Various types of seals or packing glands can be used. #3 RUDDER STUFFING BOX - A rudder stuffing box prevents the water from entering the boat through the rudder shaft hole. These brackets can be mounted between or on top of the motor stringers. To prevent the rudder from falling through the bottom of the boat, a safety collar is used on the rudder above the rudder post bracket. RUDDER POST BRACKET - The rudder post bracket supports the upper portion of the rudder and provides a bearing for the turning forces from the rudder shaft. The custom tiller is required when single push-pull cable steering is used. QUADRANT or CUSTOM TILLER - A quadrant is required when cable type steering is used. ![]() Click on the part name in blue to view that item in the Glen-L online store. Although the sketch depicts a v-drive installation, a direct in-line drive would be similar from the v-drive aft. Refer to the “V-Drive Installation” sketch to determine the location of the parts listed below. The following is a description of the various parts and their function in an inboard boat. If you’re unfamiliar with inboard installations, we suggest our book, Inboard Motor Installations. I thought it would be helpful to go over some of the parts needed. It’s at this time that we get many calls from folks asking for help with choosing hardware for their inboards. During the first part of every year is when people start outfitting their boats for the upcoming boating season.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |